1. 

   Bob
   March 27th, 2010 - 18:44

   I bought this over two years ago and it is still working fine.
   
   Easy to use. I tested it several times and the sensors each time worked. And the alarm sound is pretty loud as well.
   
   We now feel much safer when sleeping, knowing that the alarm would alert us if anyone is down stairs.
   
   Rating: 5 / 5
2. 

   Shawn Brown
   March 27th, 2010 - 18:51

   Works with ALL THREE of the SkyLink alarms I have been forced to buy before I found one I THOUGHT worked (false alarms every day!!!). But this motion sensor works very well and I recommend you buy a couple extras if you can. I put one in my garage, one in my kitchen, one in my living room, and one in my hallway. This is one way to avoid buying so many expensive door/window triggers. SkyLink offers a gray one for more money but the cheaper white one works just fine, even with other SkyLink alarms.
   Rating: 5 / 5
3. 

   O from Reno
   March 27th, 2010 - 19:14

   The seven motion sensors that I have installed have worked without a problem. They have two sensitivity settings, and I have left that setting on the default (high).
   Rating: 5 / 5
4. 

   OKC.
   March 27th, 2010 - 20:47

   I love the skylink security system. I installed about a year ago. had only two false alarms,not bad. very good motion sensors and self monitoring. dont have to pay 30 buck a month for some company to call you and tell you the alarm is going off. this system will call you and you can have it call several people. I bought this extra motion detector to instal in the basement..you can actually ad a lot of options to this system. worth everypenny and you get piece of mind.
   Rating: 5 / 5
5. 

   Simple Guy
   March 27th, 2010 - 20:51

   I’ll begin by letting you know I purchased this device in October 2008, & I don’t have pets.

   This device comes with & can be purchased separately to work with Skylink SC-1000 Complete Wireless Alarm System.

   The Good:

   It has good battery life…..(9V dc)… I haven’t changed the original battery yet in the most used sensor (i.e. covering my front door)

   I can tell you from personal experience that each one can be configured to simultaneously work with at least two Skylink SC-1000 control panels.

   The Bad:

   As with all battery operated equipment, even if it works fine you should really open the battery compartment & check for corrosion every quarter or at least half yearly. With this device you can easily forget to do so.

   The control panel doesn’t signal if a device’s battery is low, you have to pay attention to the device itself.

   The only way I have found to differentiate which sensor activated the siren was to place the ones I am least concerned about on the 1st two zones.

   As stated in the documentation there is a fixed second delay….(i.e. after being activated)….before the sensor can detect motion again.

   NOTE:
   
   I purchased three (3) extra motion sensors along with the original Skylink SC-1000 Complete Wireless Alarm System.

   I don’t regret my purchase as they are all working fine up to today….which is more than can be said for the dialer that accompanies the Complete Wireless Alarm System.

   For more on the entire system, see my opinion on the Skylink SC-1000 Complete Wireless Alarm System amazon.com product page.

   Rating: 4 / 5

Leave a comment

Name (required)

Mail (will not be published) (required)

Website

( Cancel )

CAPTCHA Code *